Table of Contents
Advertisement
Area: Areas are identified by an ID.
Default Cost: Set the cost of default-summary LSAs announced to stubby areas.
Stub Area: Configure area to be stub area.
No-Summary: Prevents ABR from injecting inter-area summaries into the specified stub area
OSPF Editor
Router ID: This sets the router-ID of the OSPF process. The router-ID may be an IP address of the router, but need not be – it can be any arbitrary 32-bit
number. However it MUST be unique within the entire OSPF domain to the OSPF speaker – bad things will happen if multiple OSPF speakers are configured with the
same router-ID.
Authentication Key: Set OSPF authentication key to a simple password. After setting authentication key, all OSPF packets are authenticated. The authentication
key has a maximum length of eight characters.
Enabled: Click to enable/disable the policy. (Default: enabled.)
Network Areas: Areas are identified by an ID number. Use the IP address and netmask fields to associate a network with this policy.
10/13/2014
CradlePoint COR IBR1100/IBR1150 – Manual
61
Advertisement
Table of Contents
