Cradlepoint COR IBR1100/IBR1150 Manual page 106

The Date Usage Rule display shows basic information for each rule you have created (including rules created with a template). The following information is displayed:
Rule Name
Enabled: True/False
Date for Rule Reset
Cycle Type: Daily, Weekly, or Monthly
Cap: Amount in MB.
Current Usage: Shown as an amount in MB, as a percentage of the cap, and in a bar graph.
Click Add to configure a new Data Usage Rule.
Data Usage Rule – page 1
Rule Name: Give your rule a name for later recognition.
WAN Selection: Select from the dropdown list of currently attached WAN devices.
Assigned Usage in MB: Enter a cap amount in megabytes. 1024 megabytes equals 1 gigabyte.
Rule Enabled: (Default: Enabled.) Click to disable.
Use with Load Balancing: When checked, the Load Balancing feature is allowed to use the thresholds and metrics of this rule when making balance decisions. This
causes Load Balancing to spread the data usage between interfaces according to the assigned usage rather than bandwidth. This is a best effort to keep all interfaces with
these rules at a similar percentage utilization of data (e.g. 10%, 50%, 90%) as the cycle progresses, rather than quickly using 100% of a fast 1 GB capped interface while
using only a fraction of a slow 10 GB capped interface, thus leaving the rest of the cycle with only the slow interface. To use this setting, you must also go to the Internet
→ WAN Affinity / Load Balancing page. For the Load Balance Algorithm field select "Data Usage".
10/13/2014
CradlePoint COR IBR1100/IBR1150 – Manual
106