Restoring Factory Defaults; Default Settings - NetComm N3G002W User Manual

Restoring Factory Defaults

This feature will reset the Router to its factory default configuration. Occasions may present themselves where
you need to restore the factory default settings on your router. Typical situations are:
• You have lost your password and unable to login to the router;
• You have purchased the router from someone else and need to reconfigure the device.
• You are asked to perform a factory reset by a member of the excellent NetComm Support Staff.
In order to restore your router to its factory default settings, please follow these steps:
• Ensure that the router is powered on (for at least 20 seconds).
• Use a paper clip or a pencil tip to depress the reset button for ten seconds and release. At this point, the
reset is in progress. Do not power off the unit at this point.
• After the router reboots, the default settings are now restored. This entire process takes several minutes
to complete.
• Once you have reset the router to its default settings you will be able to access the device's web
configuration using http://192.168.123.254 with password "admin".

Default Settings

LAN (Management)
Static IP Address:
Subnet Mask:
Default Gateway:
WAN (Internet)
WAN mode:
Wireless
SSID:
Channel:
Security:
Modem Access
Username:
Password:
N3G002W 3G Wireless Router User Guide
8
192.168.123.254
255.255.255.0
blank
DHCP
default
11
none
admin
admin
YML894 Rev1
www.netcomm.com.au