Table of Contents
Advertisement
5B Overhauling the Crank
Assembly
226. Remove the flywheel housing as well as the
protective plate under the housing and the engine
block. Tool width: 19 mm (3/4") and 13 mm.
227. Remove the flywheel damper nuts, 6 pcs. Tool
width: 13 mm. Carefully remove the damper from the
3 guide pins. Make sure that the splines are not
worn, that the springs are not damaged. Check also
that the spring package, including rivets etc., and
the damper as a whole are free from cracks.
228. Remove the center bolt of the pulley and re-
move the pulley. Tool width: 24 mm.
80
229. Remove the belt wheel and the inner guide
plate from the crankshaft. Make sure not to damage
the teeth of the belt wheel.
230. Remove the cross piece carrier from the inter-
mediate wheel. Make sure that the cross piece carri-
er is not damaged.
231. Remove the bolt holding the carrier. Use coun-
terhold part no 9995034-7. Tool width: 17 mm. Pull
off the carrier from the belt wheel.
Hide quick links:
Advertisement
Table of Contents
