Table of Contents
Advertisement
129. Set the piston for cylinder no 1 at T.D.C. Check
to make sure that the contact surface of the engine
block is properly cleaned and install a new cylinder
head gasket
130. Set the camshaft in position T.D.C. for cylinder
no 1.
131. Install the cylinder head.
58
132.
IMPORTANT! Do not turn either the crank-
shaft for the camshaft. The pistons can now
hit the valves!
Replace the cylinder head bolts in case they show
signs of elongation. If a bolt is elongated or not can
be determined by checking the 'waist' of the bolt. If
the bolt is elongated the waist of the bolt is
stretched. It is allowed to re-use the bolts a maxi-
mum of 5 times. In case of uncertainty, always re-
place the bolts with new ones.
133. Oil the threads of the cylinder head bolts and
install them. Tighten the cylinder head bolts in se-
quence and in 3 steps.
1 = 20 Nm (2.0 kpm/15 ft.lbs)
2 = 40 Nm (4.0 kpm/30 ft.lbs)
3 = angle tightening 120°.
Hide quick links:
Advertisement
Table of Contents
