Volvo Penta 230 Workshop Manual page 92

281. Install the protective plate on the underside of
the flywheel housing. Tool width: 1/2". Turn the en-
gine the right side up.
282. Oil the bearings of the intermediate shaft. Then
carefully insert the intermediate shaft in the engine
block avoiding any damage to the bearings.
283. Put a new gasket on the engine block. Cut off
any protruding parts of the gasket. Install the front
seal holder without seal rings. Install the timing mark
plate (1). Install the front screws in the oil pan. Then
tighten all the screws. Tightening torque 10 Nm (1.0
kpm/7.5 ft.lbs).
90
284. Grease the crankshaft seal abundantly and use
special tool part no 9995283-0 to install it.
NOTE!
A. If the old seal ring has not left a wear surface on
the crankshaft, the seal should be pressed in edge
to edge with the flange.
B. Should the old seal ring have left a wear mark on
the crankshaft, the new seal ring is pressed in until
the mark on the tool is edge to edge with the flange.
Be careful not to damage the seal during installation.
285. Grease the intermediate seal carefully and in-
stall it using special tool part no 9995025-5. Change
the contact surface against the shaft to give the lip
of the seal a new wear surface on the shaft. Be
careful not to damage the sealing during installation.