Receiving A Call; Group Calls; Re-Establishing A Call - Tait t2040 series ii Operator's Manual

Receiving a Call

When you receive an incoming call, your radio alerts you with a ringing tone like a telephone
and the identity of the calling party is displayed, as follows:
Message displayed Example
Label
Preset number
Identity number
System message
System message
System message
G + message
E +message
Depending on your network and how your T2040II is programmed, you can respond to the
call as follows:
You can accept the call by lifting the microphone off its hook or momentarily pressing
1
the PTT key.
You then hear the call set-up tone,
briefly before the 'call ready'
Alternatively, if you do not want to accept the call, press the Clear key (
call is then cancelled.
When your radio receives an incoming call, two short tones,
2
speaker and the
its hook. No further tones will be heard.

Group Calls

If the incoming call is a group call, you hear a single ring and then the caller broadcasts a
message to all members of your group. It is not normally necessary to reply.

Re-establishing a Call

When a call has been ended and no other function is active, your T2040II displays the identity
of the last party called. This enables you to easily re-establish a call.
12
Explanation
VEHICLE7 The calling party is one of the preset numbers with a label
programmed in your radio.
8 The calling party is one of the preset numbers without a
label programmed in your radio.
20-89 The calling party is in the same fleet as your radio but is
not preprogrammed.
OFLT Out Of Fleet: the calling party is not in the same fleet as
your radio and is not preprogrammed.
PHONE Call from the PSTN (Public Switched Telephone Network)
PABX Call from the PABX (Private Automatic Branch Exchange)
Group call
Emergency call
indicator illuminates.
GO
indicator illuminates. Answer the call by lifting the microphone off
GO
, and the
pip.. pip.. pip..
indicator illuminates
WAIT
) and the
, sound from the
beep, beep
02/99 IPN: 409-20400-02