Table of Contents
Advertisement
Switching the Radio On and Off
Switch the radio on by rotating the volume knob clockwise to about one third of its maximum
setting. You will feel a click as the knob leaves the 'off' position. The control head display then
shows a power-up message.
Switch the radio off by rotating the volume knob fully anticlockwise.
Your T2040II retains some settings when it is turned off. When you next turn it on, the radio
uses these settings.
Volume Control
A long press of the Function key (
and 'quiet'. Press and hold the Function key for at least one second to hear a sample tone
from the speaker (similar tones are emitted by the radio during normal use
Repeat this action to hear the same tone at the alternative level (normal or quiet), and select
your preferred tone level. Adjust the volume knob for comfortable listening.
Note: If the Function key (
be able to change the tone level as well.
You may need to finally adjust the volume when you receive your first call.
Checking Network Access
Check that the
indicator appears in the bottom of the display window within a few seconds
SVC
of power-up.
This shows that your radio has logged on to the network. If the
may be out of the coverage area of your network. If this is not the case consult your Tait
dealer.
1
The T2040II has either the MPT or 'Tait-standard' set of tones available. One set is selected during programming. This man-
ual refers only to the 'Tait-standard' tones.
02/99 IPN: 409-20400-02
Basic Operations
) toggles the confidence tone level between 'normal'
) is programmed to operate an auxiliary device, it may not
1
).
indicator is flashing, you
SVC
9
Hide quick links:
Advertisement
Table of Contents
