Worx WX160 Original Instructions Manual page 12

now clamped in the chuck.
6. TORqUE ADjUSTMENT (See Fig. F)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring. The torque is greater when
the torque adjustment ring is set on a higher
setting. The torque is less when the torque
adjustment ring is set on a lower setting.
Make the setting as follows:
1 - 4 for driving small screws
for driving screws into soft mate-
5 - 9
rial
for driving screws into soft and
10 - 14
hard material
15 - 19 for driving screws into hard wood
20 - 23 for driving larger screws
for heavy drilling
7. AUTOMATIc SPINDLE LOcK
(See Fig. G)
The automatic spindle lock allows you to use
12
it as a regular screwdriver. You can give an
extra twist to firmly tighten a screw, loosen
a very tight screw or continue working
when the battery energy has expired. For
manual screwdriver purposes, the chuck is
automatically locked when the tool is off.
8. USING ThE SIGhT LIGhT
The sight light allows you to keep a clear
view under less illuminated circumstances.
To turn on the light simply press the on/off
switch. When you release the on/off switch,
the light will go out.
9. LEVEL DRILLING (See Fig. h)
The bubble level is recessed in the motor
housing on the top of the drill. It can be
used to keep the drill level during horizontal
drilling operation.
The bubble level is recessed in the motor
housing on the back of the drill. It can be
used to keep the drill level during vertical
drilling operation.
Lithium-Ion cordless drill/driver
10. DRILLING
When drilling into a hard smooth surface,
use a center punch to mark the desired hole
location. This will prevent the drill bit from
slipping off center as the hole is started. Hold
the tool firmly and place the tip of the bit at
the point to be drilled. Depress the switch
trigger to start the tool. Move the drill bit
into the workpiece, applying only enough
pressure to keep the bit cutting. Do not force
or apply side pressure to elongate a hole.
Tungsten carbide drill bits should
always be used for concrete and
masonry. when drilling in metal, only
use hSS drill bits in good condition.
Always use a magnetic bit holder (not
included) when using short screwdriver
bits. when screw-driving, apply a small
quantity of liquid soap or similar to the
screw threads to ease insertion.
11. DISPOSAL OF AN EXhAUSTED
BATTERy PAcK
To preserve natural resources, please
recycle or dispose of the battery
pack properly. This battery pack
contains Lithium batteries. Consult your local
waste authority for information regarding
available recycling and/or disposal options.
Discharge your battery pack by operating
your drill, then remove the battery pack
from the drill housing and cover the battery
pack connections with heavy-duty adhesive
tape to prevent short circuit and energy
discharge. Do not attempt to open or remove
any of the components.
12. OVERLOAD PROTEcTION
When overloaded, the motor comes to
a stop. Relieve the load on the machine
immediately and allow cooling for approx. 30
seconds at the highest no-load speed.
13. TEMPERATURE DEPENDENT
OVERLOAD PROTEcTION
When using as intended for the power tool
cannot be subject to overload. When the
load is too high or the allowable battery
temperature of 75°C is exceeded, the
electronic control switches off the power
EN