Hangar 9 P-51D Mustang Sport 40 ARF Assembly Manual page 9


Step 13
Place the receiver in the opening in the foam. Make sure
the antennas on the receiver are straight to allow for the
best reception of radio signals. Tuck the servo leads neatly
in the fuselage.
note 1: Some receivers may require the foam to be cut
to fit properly.
note 2: If you are using a 2.4GHz radio system, it is
recommended to bind the receiver to the transmitter
at this time and check the operation of the servos that
are plugged into the receiver. Follow the instructions
provided with your radio for the procedure to bind the
receiver to the transmitter if necessary.

Step 14
Place the remaining pre-cut foam over the receiver to fill the
receiver area. The amount of foam will be dependant on your
choice of receiver.
Hangar 9 P-51D Mustang Sport 40 Assembly Manual

Step 15
Secure the receiver hatch in place using four #2 x 3/8-inch
self-tapping screws and a #1 Phillips screwdriver. Note the
location of the blind nuts in the receiver hatch in the photo.
noTE: SPECIAL ConSIDERATIon
FoR ELECTRIC MoDELS

EP Step A
When installing an electric power system you must install
the hook and loop straps that secure the motor battery. The
first strap is placed in the forward of the fuselage as shown.

EP Step B
The second strap is installed in the receiver hatch before it is
placed in the fuselage.

Step 16
Mount the remote receiver inside the fuselage using hook
and loop material. Note the direction of the antenna on
the receiver.
9