Wiring Connection; Part List For Installation - Kenwood KDC-BT600U Instruction Manual

Wiring connection

Rear/ Front/ Subwoofer output
For 3-way crossover: Tweeter/
Mid Range/ Woofer output
Antenna terminal
To front speaker (left) / For 3-way
crossover: Mid range speaker (left)
To front speaker (right) / For 3-way
crossover: Mid range speaker (right)
To rear speaker (left)
For 3-way crossover: Tweeter (left)
To rear speaker (right)
For 3-way crossover: Tweeter (right)
Ignition switch
Car fuse box
Car fuse box
Black (Ground wire)
To the metallic body or chassis of the car
Battery
Rear/ subwoofer output
For 3-way crossover:
Woofer output
White
White/Black
Gray
Brown
Gray/Black
(Mute control wire)
Green
Green/Black
Purple
Purple/Black Blue/White
(Power control wire/
Antenna control wire)
Red (Ignition wire)
Light blue/yellow
Yellow (Battery wire)
(Steering remote
control wire)
IMPORTANT : We recommend installing the unit with a
commercially available custom wiring harness specific for
your car and leave this job to professionals for your safety.
Consult your car audio dealer.
When connecting to an external amplifier, connect its ground
wire to the car's chassis to avoid damaging the unit.
Fuse (10 A)
Microphone input jack ( 12)
If no connections are made, do not let the wire come out from the tab.
To connect the Kenwood
navigation system, refer your
navigation manual
To the power control terminal
when using the optional power
amplifier or to the antenna
control terminal in the vehicle
To the steering wheel remote
control adapter

Part list for installation

(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
(F) Screws (supplied for
)
27
ENGLISH