Other Messages - Hitachi RX Instruction Manual

No. Message
87 Ink Pressure High Ink pressure value is not at the proper level.
88 Battery Low C
93 Ink Pressure Low
Product Speed
95
Matching Error
129 Model-key Failure A fault was generated in the hardware.
Language-key
130
Failure

9.2.3 Other messages

No. Message
Ink Temperature
187
Correction Notice
Print Data/Settings
199
Notice
No Ink
200 Concentration
Control
USB Memory
210
Error
Meaning of message
The controller section built-in battery
voltage is too low.
Ink pressure value is not at the proper level.
The encoder pulse rate exceeds the
available printing speed.
A fault was generated in the hardware.
Meaning of message
The selected setup does not allow ink
temperature corrections to be made.
( P1-4)
Recent changes to print data and printer
settings may have been lost. In the previous
session, power was cut OFF suddenly.
The current settings have made ink
concentration control unavailable.
( P1-5)
USB memory is not inserted. Or an error
was generated when reading USB memory.
Remedy
● Operate the pressure-reducing
valve to adjust the pressure.
● Contact your nearest local
distributor.
● When making prints, set the
correct calendar time again
from the date/time setup
screen ( 6.2).
● Operate the pressure-reducing
valve to adjust the pressure.
● Slow the print target speed.
● Decrease N in the ink drop
use percentage (1/N).
( 4.13.1).
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
Remedy
● Contact your nearest local
distributor.
● Check print contents and each
setting value.
● Contact your nearest local
distributor.
●Insert correctly.
●Replace with a new USB
memory.
●On-screen message descriptions 9-8