Sanyo PLC-XF47 Service Manual page 79

■ CONVERGENCE ADJUSTMENT TOOL INSTALLATION AND REMOVAL
Note; Before mounting the Adjustment Tool, set adjustment screws of Adjustment Tool in center of the adjustment range.
Refer to Screw Setting.
1. Loosen 2screws-A of Prism/LCD panel unit.
CAUTION: When loosening the screws-A, do not touch the other mechanical part or give it shock.
2. Fully loosen 2screws-B on the Adjustment Tool.
3. Fully slide the Adjustment Tool part-A into the LCD Panel Bracket hole.
4. Mount Adjustment Tool on the Prism/LCD panel unit with screws-C attached with Adjustment Tool along the guide on
top of Prism Ass'y.
CAUTION: Do not use other kind of screws for mounting, otherwise Prism/LCD panel unit may be damaged.
5. Tighten screws-B and hold the LCD Panel Bracket.
Loosen 2 Screws-B before installation.
Screw-B
Adjustment Tool
Prism/LCD Panel
unit
Step 2
LCD Panel bracket
Screw-B
LCD Panel Bracket
Insert Adjustment Tool Leg (2 Legs) into
LCD Panel Bracket holes, and tighten
screws-B and hold LCD Panel Bracket
with Adjustment Tool.
Tighten 2 Screws-B and
hold the LCD Panel bracket
Slide the
Adjustment Tool.
Step 3
Part-A
Adjustment
Tool
- 79 -
Tighten 2 Screws-C and
hold the Prism/LCD Panel
unit
Screw-C
Step 4
Prism/LCD Panel unit
LCD Panel
Bracket hole
Screw-A
Optical adjustment