Sony RM-LVR2 How To Use Manual page 14

Press the ON/OFF (Power) button.
3. Check the camera setting.
Action Cam excluding HDR-AZ1
HDR-AZ1/Lens-style Camera (QX series)
Check that a Wi-Fi mark is displayed on the display panel of the camera.
For DSC-QX100/QX10, the Wi-Fi indicator is not displayed on the camera display.
If the connection mode of the camera is set to the multi connection, switch to the single connection.
For HDR-AS15/AS30V, insert a memory card to the camera.
4. Select the camera you want to connect to this unit.
i. Press the UP button or DOWN button to select the SSID (the destination) from the list.
ii. Press the REC/ENTER button.
iii. When this unit is in the standby status, proceed to step 5 within 2 minutes.
If you press the REC/ENTER button in the standby status, the remote control will be released from
the standby status. In this case, select the SSID of the camera again.
If the SSID is not displayed, check that the camera is in single connection mode. Refer to the Help
Guide of the camera on the website for how to check the connection mode of the camera.