Temperature Alarm - Clas Ohlson WS2015H User Manual

Note: The sensor's display goes down to -50 degrees. The main display unit (receiver)
only displays temperatures down to -30 degrees. If the temperature falls below -30,
"LO" appears on the display.
Displaying the temperature trend
The temperature trend is read every half-hour and is shown with arrows as follows:
Indicator
Trend
External temperature sensor
The sensor is equipped with a socket
for connecting the supplied external
temperature sensor.
1. Connect the external temperature sensor
to the internal sensor.
2. When the external temperature sensor
is connected, the following appears on
the display:
• The temperature at the external sensor
• The OUT symbol
• The humidity at the external sensor
4.2 Temperature alarm
You can decide if you want the alarm to warn you when the temperature reaches
a certain level. You can set two alarms at the same time – one for the receiver and
one for a sensor.
Indoor temperature alarm (receiver)
1. Press [Mode/Snooze] repeatedly to get to
the indoor temperature alarm setting mode.
will appear.
2. Press [Alarm/C/F] repeatedly to switch between
temperature alarms for high and low temperatures
and also to activate the alarm.
• If the temperature is rising, the arrow in the "trend" box will point upwards.
• If the temperature is falling, the arrow in the "trend" box will point downwards.
• If the trend arrow is not shown, it means that the temperature alarm is deactivated.
3. Press [Hour/+/Max] or [Minute/-/Min] to set the temperature for when the alarm
should sound.
4. Press [Mode/Snooze] to confirm the setting.
Rising
9
Steady
1 1
Falling
2
1 O U T
1
O U T 1 O U T O U T