Temporis Ip700G Installation - Alcatel Temporis IP100 Administration And Provisioning Manual

Temporis IP700G installation

To install the phone:
1. If you plan to place the phone on a flat surface, you can use one of the multiple
available positions depending on the work angle you wish to have. Simply adjust the
foot stand with the slots on the rear of the phone as shown in the picture
2. Plug the end of the coiled handset cord into the Handset jack at the left hand side of
the phone.
3. Plug one end of the Ethernet cable into the Ethernet port at the back of the console,
and plug the other end of the cable into your network router or switch.
NOTE: You may need to use a network switch connected to your router if your router
does not have sufficient ports for the number of phones you want to install. If you use
a network switch, connect the phone to the switch instead of the router in the
previous step.
4. If the desk set is not using power from a PoE-capable network router or switch:
Business IP Range Administration and Provisioning Guide ed 1.0 26/175