Turning On The Projector - NEC WT615 User Manual

This section describes how to turn on the projector and to project a picture onto the screen.

Turning on the Projector

NOTE:
• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on the
remote control).
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off ( )
position. Failure to do so may cause damage to the projector.
• The projector has a feature to prevent itself from being used by unauthorized individuals. To use this feature, register a
keyword. See "Security" in "Setup" on page
1. Open the mirror cover. See page
2. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The POWER indicator will light orange.
See the Power Indicator section on page
details.
3. Press the POWER (ON/STAND BY) button on the
projector cabinet or POWER ON button on the
remote control for a minimum of 2 seconds, when
the PWOER indicator turns a steady green the
projector is ready to use.
• After you turn on your projector, ensure that the
computer or video source is turned on.
NOTE: If you turn on the projector immediately after the lamp
is turned off or when the temperature is high, the fans run
without displaying an image for some time and then the
projector will display the image.
NOTE: When no signal is available, a blue, black or logo screen is displayed.
57 for more details.
6 for more details.
138 for more
See page
31
3. Projecting an Image (Basic Operation)
Cabinet controls
ENTER EXIT
3D
REFORM
AUTO
ADJUST
POWER
ON/ STATUS
STAND BY
LAMP
Standby
LAMP
STATUS
POWER
ON/
STAND BY
Steady orange
light
Press this button for a
minimum of 2 seconds.
138 for more details.
POWER
STATUS
LAMP
Remote control
OFF ON
POWER
LASER
MAGNIFY PAGE
UP
POINTER
DOWN
Blinking for
Power On
one minute
LAMP LAMP
STATUS STATUS
POWER POWER
Blinking green Steady green
light light