Making Connections; When Viewing A Dvi Digital Signal; Connecting Your Pc Or Macintosh Computer - NEC WT615 User Manual

Making Connections

NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the
power to the notebook PC. In most cases signal cannot be output from the RGB output unless the notebook PC is turned on after
connecting with the projector.
* If the screen goes blank while using your notebook PC, it may be the result of the computer's screen-saver or power manage-
ment software.

When Viewing a DVI Digital Signal

To project a DVI digital signal, be sure to connect the PC and the projector using a DVI cable (not supplied) before
turning on your PC or projector. Turn on the projector first and select DVI (DIGITAL) from the source menu before
turning on your PC.
Failure to do so may not activate the digital output of the graphics card resulting in no picture being displayed. Should
this happen, restart your PC.
Do not disconnect the DVI cable while the projector is running. If the signal cable has been disconnected and then re-
connected, an image may not be correctly displayed. Should this happen, restart your PC.
NOTE:
• Use a DVI cable or the one compliant with DDWG (Digital Display Working Group) DVI (Digital Visual Interface) revision 1.0
standard. The DVI cable should be within 5 m (196") long. Both single and dual types of DVI cable can be used.
• The DVI (DIGITAL) connector accepts VGA (640x480), SVGA (800x600), 1152x864, XGA (1024x768) and SXGA (1280x1024 @
up to 60Hz).

Connecting Your PC or Macintosh Computer

IBM PC or Compatibles (Desktop type)
or Macintosh (Desktop type)
NOTE: For older Macintosh, use a commercially available pin adapter (not supplied) to connect to your Mac's video port.
NOTE: The WT615/WT610 is not compatible with video decoded outputs of either the NEC ISS-6020 or ISS-6010.
COMPUTER IN
DVI-I IN
REMOTE PCCONTROL
IN
S-VIDEO IN
AUDIO IN VIDEO IN
R L
/MONO
DVI cable (not supplied)
PHONE
Audio cable (not supplied)
AUDIO IN DVI-I
AUDIO IN COMPUTER
PC CARD USB AUDIO IN AUDIO OUT
DVI-I COMPUTER
DVI-I IN
COMPUTER IN MONITOR OUT
PHONE
IBM VGA or Compatibles (Notebook type)
or Macintosh (Notebook type)
19
2. Installation and Connections
Audio cable (not supplied)
RGB/VGA signal cable
(supplied)
To mini D-Sub 15-pin
connector on the projector.
It is recommended that
you use a commercially
available distribution
amplifier if connecting a
signal cable longer than
the one supplied.