Connecting An External Monitor - NEC WT615 User Manual

Connecting an External Monitor

You can connect a separate, external monitor to your projector to simultaneously view on a monitor the RGB analog
image you're projecting. To do so:
1. Turn off the power to your projector, monitor and computer.
2. Use a 15-pin cable to connect your monitor to the MONITOR OUT (Mini D-Sub 15 pin) connector on your
projector.
3. Turn on the projector, monitor and the computer.
NOTE:
• When the projector is in the Standby mode, the image may not be correctly displayed while the cooling fans are running
immediately after turning on or off the power. Note that the MONITOR OUT connector will not output an RGB signal during
Power-saving mode (See page
• Daisy chain connection is not possible.
REMOTE PCCONTROL PC CARD
IN
S-VIDEO IN DVI-I IN
AUDIO IN VIDEO IN
R L
/MONO
RGB/VGA signal cable
(supplied)
To mini D-Sub 15-pin
connector on the projector.
It is recommended that you
use a commercially
available distribution
amplifier if connecting a
signal cable longer than the
supplied one.
119 for enabling the Power-saving mode).
2. Installation and Connections
MONITOR OUT
USB AUDIO IN AUDIO OUT
DVI-I COMPUTER
COMPUTER IN MONITOR OUT
RGB/VGA signal cable (commercially
available or supplied with an external
monitor)
22