Adjusting The Security Settings; Password Prompt - Abus TVIP62000 User Manual

3.11 Adjusting the security settings

Note: Your PC security settings may prevent a video stream. You can change the security
settings to a lower level under "Tools/Internet Options/Security". Make sure you enable ActiveX
controls and downloads.

3.12 Password prompt

An administrator password is defined in the network camera as standard. However, the administrator should
define a new password immediately for security reasons. After the new administrator password is stored, the
network camera asks for the user name and password every time it is accessed.
The administrator account is set as follows (factory setting): User name = "admin"; password = "12345". Each
time the network camera is accessed, the browser displays an authentication window and asks for the user
name and password. If you can no longer access your personal settings in the administrator account, you can
log in again with "admin"/"12345" after resetting the network camera to the factory settings.
To enter a user name and password, proceed as follows:
Open Internet Explorer and enter the IP address of the camera (e.g. "http://192.168.0.200").
You are then prompted for authentication:
54