Smart Phone Control; Boundary Wire Basics; Pegging The Boundary Wire; Burying The Boundary Wire - Worx Landroid WG797E Original Instructions Manual

4.

Smart phone control

®
Your Lanroid L(WG797E) could be connected to smart phone. All the
general settings could be set on your phone. It will also show the
current working status, even errors. For the details settings, please
®
refer to the Lanroid L Wifi Connection Guide.
5.

Boundary Wire Basics

5.1 Pegging the Boundary Wire

Use the Boundary Wire Distance Gauge (26) to set the correct
distance from the border of your lawn (More than 45cm *).
* This is the recommended distance. Use the provided distance
gauge to ensure proper installation.
If your neighbor also uses a Landroid
and your neighbors.
Please be aware that your Landroid
The boundary wire must outline the intended mowing area exactly. Your Landroid
extra bends or coils of Boundary Wire that are not part of its mowing area (See Fig. H). If there is excess Boundary Wire
after the mowing area has been outlined, then cut it off and store this additional wire in a separate location. However, it is
important to leave the necessary length where it connects to the Charging Base so it can be connected and still remain
buried.

5.2 Burying the Boundary Wire

If you are planning to bury the Boundary Wire then it should be noted that when entering its Charging Base for the first
®
time, your Landroid L may find problems with the way you have laid the wire. It is recommended to first peg down the
Boundary Wire to the lawn so it is easy to make adjustments if necessary. This will allow the Landroid
adjusted to its new environment and ensures it will successfully work with the charging base before the Boundary Wire is
buried.
When you have completed installing the boundary wire, it is
recommended that you ask Landroid
by pressing the home button.
Whilst observing Landroid
then make alterations to the boundary wire route to ensure trouble
free tracking of the boundary wire by Landroid
charging station.

5.3 Joining the Boundary Wire

The Boundary Wire (23) can be extended simply by splicing the ends
and connecting it to the ends of another piece of wire. You can use
insulating tape to secure the joined part of the wire. (See Fig. I)

5.4 Turn on and test installation

If the charger base LED does not come on, then check the power connections.
If the charger base LED is flashing green, check if the boundary wire is connected correctly.
Red light on: charging.
Red light flashing: error message, refer to Trouble Shooting and correct the problems.
Green light flashing: check if the boundary wire is connected correctly.
When the green light on the charging base is on, place your Landroid
boundary it is connected correctly.
®
If your Landroid L is inside its territory but the display says "Outside working area" and the LED is on, it means you
clamped the boundary wire ends incorrectly. Just reverse them.
Lawn Mowing Robot
®
L, then you must keep a spacing of at least 2 metres between your Boundary Wire
®
L will not be able to receive a signal from the Boundary Wire beyond the distance of 25m.
®
L to follow the boundary wire
®
L locating the charging station you can
®
L when locating the
H
®
Lwill become confused by
I
®
L over the boundary wire, if Landroid
®
L to become
®
L follows the
EN
11