Yamaha YZF-R1V Supplementary Service Manual page 29

Pass the lead through inside of
the battery band.
Press on the tip of the clamp
after passing the leads through
it.
Insert the tail /brake light lead to
the rear frame hole.
Insert the clamp from the vehi-
cle front to the rear side and fas-
ten each lead, coupler and
onionhead to the fender rib, and
then point the tip of the clamp
(excessive part) to the upper
side of the vehicle.
Hold down the clamp tips after
passing each lead.
CABLE ROUTING
Make sure to position the cou-
pler at the downmost position of
leads. However, the coupler
should be set in the rear frame
so that it is not caught by the
seat bottom, cover and other
components.
Point the tip of the clamp
(excessive part) to the inside of
the vehicle. Fasten the wire har-
ness with a clamp.
21
SPEC
Point the tip of the clamp (sur-
plus section) to the rear side of
the vehicle. Fasten the starter
relay lead, turn signal relay
lead, main fuse lead, main fuse
lead (from the battery positive
lead) and starting circuit cut-off
relay lead with a clamp.
Route each lead upper side the
wire harness.
Fasten the wire harness, battery
negative lead and starter motor
lead with a clamp. Point the tip
of the clamp (excessive part) to
the inside of the vehicle.