Yamaha YZF-R1V Supplementary Service Manual page 23

Wire harness
Crankshaft position sensor lead
Heat protector
Right handlebar switch lead
Positioning guide
Rear brake light switch lead
Coolant reservoir tank
Speed sensor lead
Clutch cable
Radiator
Oil cooler outlet hose
Coolant reservoir tank drain
hose
Breather pipe
Fuel tank drain hose
A.C. magneto lead
Wire harness
CABLE ROUTING
Throttle body lead
Clamp it after passing between
the frame and radiator stay.
Point the tip of the clamp
(excessive part) to the front side
of the vehicle. Fasten the right
handlebar switch lead with a
clamp.
To the wire harness
The clutch cable positioning
guide should be above the
upper end of the clamp. Fasten
the clutch cable with a clamp.
(Refer to )
Position relation between the
clamp and guide.
for CAL
15
SPEC
Clamp the clamp upper end
along the line of lower end of
the hose clamp assembly. Point
the tip of the clamp (excessive
part) to the front side of the
vehicle. Clutch cable is what the
clamp fastens.
The clutch cable doesn't project
outside the water hose and the
cylinder head in the box part in
the figure.
To the engine
Clamp behind the bracket 3.
Cut the tip of the clamp.