Table of Contents
Advertisement
Outputting Trunk Signal
When connected to the HXC-D70 HD Color Camera
You can communicate with an external device that is connected to the TRUNK
connector (RS-232C) or REMOTE connector of the HXC-D70, and an external
device that is connected to the TRUNK connector of the CCU.
To output trunk signal from the HXC-D70
Configure the following menu (MAINTENANCE menu M14: <TRUNK>) of the HXC-
D70.
Configure IF (interface) according to the connected device.
Menu page
Item
<TRUNK>
TRUNK
IF
* default setting.
Using an Intercom
You can talk to the CCU operator by attaching an intercom headset to the
INTERCOM connector of the adaptor.
When connected to the HXC-D70 HD Color Camera
The INTERCOM connector of the HXC-D70 is also available for communication with
the CCU operator. The talk line of the HXC-D70 can be controlled by the INTERCOM
line switch of the adaptor.
• Configure the settings of the connected intercom headset in the OPERATION
menu of the HXC-D70.
13 <HEAD SET>: Settings for input of the headset's microphone
14 <INTERCOM LEVEL>: Settings for the SIDE TONE level of the headset
The displayed items in the above menu are as follows:
INTERCOM1 (CAM): Intercom settings of the HXC-D70
INTERCOM2 (CA): Intercom settings of the adaptor
For details of the setting items, refer to the operating instructions of the HXC-D70.
When you do not use the INTERCOM connector of the HXC-D70, set the
INTERCOM ON/OFF switch of the HXC-D70 to OFF.
• The adaptor can control one PGM (program audio) system.
An audio signal that is input to the PGM1 of CCU is transmitted.
Setting
Description
OFF
Disable the trunk signal output
ON*
Enable the trunk signal output
232c*
Outputs from the TRUNK connector
via RS-232C I/F
422a
Outputs from the REMOTE connector
via RS-422A I/F
Preparation and Setting
13
Advertisement
Table of Contents
