Initial Start-Up; Assembling The Mounting Bracket; Attaching The Mounting Bracket - FALK Flat XL Quick Start Manual

3. Initial start-up

On the following pages, you will be guided step by
step through the procedure you need to follow when
you first set up your navigation product. Depending on
the product, the functions, product features or compo-
nents which are described may differ. For this reason,
it is pointed out that in every case the description on
the packaging takes precedence in specifying which
functions your product features.

Assembling the mounting bracket

Enclosed with your F-Series device is a mounting brack-
et, consisting of a device shell and a mounting bracket
base. You can use the mounting bracket to attach your
device to the windscreen or the dashboard in your car.
You must first lock your device in place in the shell for
the device. To do this, place the device from above onto
the device shell, so that the recesses on the bottom
of the device marry up with the protuberances on the
mounting bracket for the device. There is a magnet both
in the holding shell and on the back of the device. You
should now press the entire back of the device against
the mounting bracket. When the device is in the correct
position, you will hear it lock in place.
The device can now be connected via the device shell
to the base of the mounting bracket. This is done via
the back of the device mounting bracket, which must
be locked into the square plate of the mounting bracket
base.
Note: When you wish to remove the device again from
the device shell, you should grip the holding shell with
one hand. Pull the device up and forwards with your
other hand.
Attention: Do not remove the device by pulling it up
vertically.

Attaching the mounting bracket

Locate a flat spot on the windscreen or dashboard
where you can attach the mounting bracket. You
should also clean the appropriate spot. You should not
fit the bracket at temperatures of below +15°C.
Note:
Do not attach at a point
which might impair the
driver's view.
Do not use on coverings
for the airbags.
Firmly attach the base of the mounting bracket and
push the locking lever away from yourself. This causes
the suction base to suck tight onto the surface below.
If you want to remove the base of the mounting bracket
again, pull the locking lever towards yourself.
Do not leave lying
unattached on the
dashboard.
Do not attach at a point
where airbags may open.
EN
25