NEC LT265 User Manual page 36

Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one
of the 21 menu languages.
To select a menu language, follow these steps:
1. Use the SELECT
21 languages for the menu.
2. Press the ENTER button to execute the selection.
3. To close the menu, press the EXIT button.
NOTE: Immediately after turning on the projector and
displaying an image, you cannot turn off the projector for 60
seconds.
After this has been done, you can proceed to the menu op-
eration.
If you want, you can select the menu language later. See "Lan-
guage" on page 91.
NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp
lighting is stabilized.
When the Lamp mode is set to Eco, the Lamp indicator will light green.
If one of the following things happens, the projector will not turn on.
• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this
condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal
components to cool down.
• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp. See
page 119.
• If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and
then turn on the power.
or button to select one of the
3. Projecting an Image (Basic Operation)
SOURCE
SELECT
3D REFORM
PC CARD
SOURCE
SELECT
3D REFORM
PC CARD
SELECT
3D REFORM
PC CARD
29
OFF
MAGNIFY
AUTO ADJUST
LAMP
STATUS
ON/STAND BY POWER
OFF
MAGNIFY
AUTO ADJUST
LAMP
STATUS
ON/STAND BY POWER
OFF
MAGNIFY
SOURCE AUTO ADJUST
POINTER
LAMP
STATUS
ON/STAND BY POWER
ON
POWER
LASER
PAGE
UP
POINTER
DOWN
ON
POWER
LASER
PAGE
UP
POINTER
DOWN
ON
POWER
LASER
PAGE
UP
DOWN