Turning On The Projector - NEC LT265 User Manual

This section describes how to turn on the projector and to project a picture onto the screen.

Turning on the Projector

NOTE:
• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on the
remote control).
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off ( )
position. Failure to do so may cause damage to the projector.
• The projector has a feature to prevent itself from being used by unauthorized individuals. To use this feature, register a
keyword. See "Security" in "Setup" on page
1. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The POWER indicator will light orange.
See the Power Indicator section on page
details.
2. Press the POWER (ON/STAND BY) button on the
projector cabinet or POWER ON button on the
remote control for a minimum of 2 seconds when the
power indicator turns a steady green, and the
projector is ready to use.
• After you turn on your projector, ensure that the
computer or video source is turned on and that your
lens cap is removed.
NOTE: When no signal is available, a blue, black or logo screen is displayed.
3. Projecting an Image (Basic Operation)
48 for more details.
123 for more
Steady orange
See page
28
SOURCE AUTO ADJUST
SELECT
STATUS
3D REFORM ON/STAND BY
PC CARD
Standby
LAMP
STATUS
POWER
ON/STAND BY
Blinking green
light
Press this button for a
minimum of 2 seconds.
123 for more details.
LAMP
STATUS
POWER
OFF ON
POWER
LASER
MAGNIFY PAGE
UP
POINTER
LAMP
DOWN
POWER
Blinking for
Power On
one minute
LAMP LAMP
STATUS STATUS
POWER POWER
Steady green
light light