Optimizing An Rgb Image Automatically; Turning Up Or Down Volume - NEC LT265 User Manual

Optimizing an RGB Image Automatically

Adjusting the Image Using Auto Adjust

Optimizing an RGB image automatically.

Press the Auto Adjust button to optimize an RGB image automatically.
[Poor picture]
[Normal picture]
Press the Auto Adjust button to fine-tune the computer image or to remove any vertical banding that might appear and
to reduce video noise, dot interference or cross talk (this is evident when part of your image appears to be shimmer-
ing). This function adjusts the clock frequencies that eliminate the horizontal banding in the image. This function also
adjusts the clock phase to reduce video noise, dot interference or cross talk.
This adjustment may be necessary when you connect your computer for the first time.
NOTE:
• Some signals may not be displayed correctly or take time.
• The Auto Adjust function does not work for component or video signals.
• If the Auto Adjust operation cannot optimize the RGB signal, try to adjust Clock and Phase manually. See page 86.

Turning Up or Down Volume

Sound level from the speaker and the AUDIO OUT
jack (Stereo mini) on the projector can be adjusted.
NOTE: When no menus appear, the SELECT
on the projector cabinet work as a volume control.
3. Projecting an Image (Basic Operation)
SOURCE AUTO ADJUST
SELECT
LAMP
STATUS
3D REFORM ON/STAND BY POWER
PC CARD
buttons
Increase volume
Decrease volume
35
VIDEO LAN
COMPUTER
1
S-VIDEO VIEWER
2
PIC-MUTE SLIDE
AUTO ADJ.
VOLUME HELP
ASPECT PICTURE
FREEZE 3D REFORM
VIDEO COMPUTER LAN
1
S-VIDEO VIEWER
2
PIC-MUTE AUTO ADJ. SLIDE
VOLUME HELP
ASPECT PICTURE
FREEZE 3D REFORM