Connecting Your Dvd Player With Component Output - NEC LT265 User Manual

Connecting Your DVD Player with Component Output

Optional 15-pin - to - RCA (female) 3 cable
(ADP-CV1)
Y
Component
You can connect your projector to a DVD player with component output or Video output. To do so, simply:
1. Turn off the power to your projector and DVD player.
2. If your DVD player has a component video (Y,Cb,Cr) output, use a commercially available component video cable
(RCA 3) and the optional 15-pin-to-RCA (female) 3 cable to connect your DVD player to the COMPUTER IN
connector on the projector.
For a DVD player without component video (Y,Cb,Cr) output, use an S-Video cable (not provided) to connect an S-
Video output of the DVD player to the Video Input of the projector.
3. Connect the supplied power cable. See page 26.
4. Turn on the projector and DVD player.
A component signal will be automatically displayed. If not, from the menu, select [Setup]
Select] [Computer 1 (or 2)]
NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.
COMPUTER 1 IN
PC CARD
R AUDIO IN L VIDEO IN S-VIDEO IN PC CONTROL
AC IN
Component video RCA 3
cable (not supplied)
DVD player
Cb Cr L R
AUDIO OUT
[Component].
AUDIO OUT
LAN USB
COMPUTER 1 IN AUDIO IN COMPUTER 2 IN MONITOR OUT
Audio Equipment
Audio cable (not supplied)
20
2. Installation and Connections
AUDIO IN
L R
[Options] [Signal