Connecting Your Vcr Or Laser Disc Player - NEC LT180 User Manual

Connecting Your VCR or Laser Disc Player

S-Video cable
(not supplied)
VCR/ Laser disc player
L R
AUDIO OUT
Use S-Video or RCA cables to connect your VCR, laser disc player or document camera to your projector.
To make these connections, simply:
1. Turn off the power to the projector and VCR, laser disc player or document camera.
2. Connect one end of your RCA or S-Video cable to the video output connector on the back of your VCR or
laser disc player, connect the other end to the VIDEO IN or S-VIDEO IN on your projector. Use an audio cable
to connect the audio from your VCR or laser disc player to your audio equipment (if your VCR or laser disc
player has this capability). Be careful to keep your right and left channel connections correct for stereo sound.
3. Turn on the projector and the VCR or laser disc player.
NOTE: Refer to your VCR or laser disc player owner's manual for more information about your equipment's video output
requirements.
NOTE: An image may not be displayed correctly when a Video or S-Video source is played back in fast-forward or fast-rewind
via a scan converter.
S-VIDEO IN
AUDIO OUT
Y Cb/Pb
MONITOR OUT COMPUTER IN
PC CONTROL
Cr/Pr
AUDIO IN COMPONENT IN
VIDEO IN
S-VIDEO VIDEO
VIDEO OUT
Audio cable
(not supplied)
2. INSTALLATION AND CONNECTIONS
AUDIO IN
S-VIDEO IN
L
VIDEO IN R AUDIO IN
AC IN
Video cable
(not supplied)
Audio equipment
E-18
AUDIO IN
L R