Making Connections; Connecting Your Pc Or Macintosh Computer - NEC LT180 User Manual

Making Connections

Connecting Your PC or Macintosh Computer

NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the
power to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook PC is turned on after
connecting with the projector.
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power
management software.
RGB/VGA signal cable (supplied)
To mini D-Sub 15-pin connector on the projector. It
is recommended that you use a commercially avail-
able distribution amplifier if connecting a signal
cable longer than the one supplied.
NOTE: For older Macintosh, use a com-
mercially available pin adapter (not sup-
plied) to connect to your Mac's video port.
PHONE
IBM PC or Compatibles (Desktop type)
or Macintosh (Desktop type)
Connecting your PC or Macintosh computer to your projector will enable you to project your computer's screen
image for an impressive presentation.
To connect to a PC or Macintosh, simply:
1. Turn off the power to your projector and computer.
2. Use the supplied RGB/VGA signal cable to connect your PC or Macintosh to the projector.
3. Turn on the projector and the computer.
4. If the projector goes blank after a period of inactivity, it may be caused by a screen saver installed on the
computer you've connected to the projector.
2. INSTALLATION AND CONNECTIONS
COMPUTER IN
AUDIO OUT
PC CONTROL MONITOR OUT COMPUTER IN
AUDIO IN
E-14
AUDIO IN
S-VIDEO IN
Y Cb/Pb
L
Cr/Pr
COMPONENT IN VIDEO IN R AUDIO IN
AC IN
Audio cable (not supplied)
IBM VGA or Compatibles (Notebook type)
or Macintosh (Notebook type)
PHONE