What's In The Box - NEC LT180 User Manual

Lamp Replacement
• To replace the lamp, follow all instructions provided on page E-44.
• Be sure to replace the lamp when the message "The lamp has reached the end of its usable life. Please
replace the lamp." appears. If you continue to use the lamp after the lamp has reached the end of its usable
life, the lamp bulb may shatter, and pieces of glass may be scattered in the lamp case. Do not touch them as
the pieces of glass may cause injury.
If this happens, contact your dealer for lamp replacement.
• Allow a minimum of 60 seconds to elapse after turning off the projector. Then turn off the main power switch,
disconnect the power cable and allow 60 minutes to cool the projector before replacing the lamp.

What's in the Box?

Make sure your box contains everything listed. If any pieces are missing, contact your dealer.
Please save the original box and packing materials if you ever need to ship your Projector.
Projector
O L
N TR
C O
Lens cap
Band (use for bundling cables)
(24B17871)
CD-ROM
User's manual
O IN
ID E
S -V
on o
L/ m
P b
C b/
IN
D IO
A U
Y
R
IN
E O
V ID
P r
C r/ T IN
E N
O N
M P
C O
IN IN
E R D IO
U T
A U
M P
C O
T
O U IN
O R A C
N IT
M O
1
Soft case
(24BS7471)
Shoulder belt
IMPORTANT INFORMATION
Remote control (7N900601)
Power cable
(US: 7N080213)
(EU: 7N080007)
2
E-iv
Batteries (AAA 2)
RGB/VGA signal cable
(7N520032)
Quick Setup Guide
Important Information
For North America only
Registration card
Limited warranty
For Europe only
Guarantee policy