Connecting Your Vcr Or Laser Disc Player - NEC GT6000 User Manual

Connecting Your VCR or Laser Disc Player

Audio cable (not supplied)
VCR/ Laser disc player
Use common RCA cables (not provided) to connect your VCR, laser disc
player or document camera to your projector.
To make these connections, simply:
1. Turn off the power to the projector and VCR, laser disc player
or document camera.
2. Connect one end of an RCA cable (not supplied) to the video
output connector on the back of your VCR or laser disc player,
connect the other end to the Video input on your projector (an
RCA to BNC adapter is necessary). Use an audio cable (not
supplied) to connect the audio from your VCR or laser disc
player to your audio equipment (if your VCR or laser disc player
has this capability). Be careful to keep your right and left chan-
nel connections correct for stereo sound.
3. Turn on the projector and the VCR or laser disc player.
DVI
AUDIO
AUDIO OUT RGB 1
SLOT 1 SLOT 2
L/MONO L/MONO
R R
AUDIO
RGB 2
R/Cr
G/Y
RGB OUT
VIDEO
S-VIDEO
B/Cb
VIDEO S-VIDEO
H/
HV
V
L/MONO L/MONO
R R
L R S-VIDEO VIDEO
AUDIO OUT VIDEO OUT
USB A USB B PC CARD
LAN
PC CONTROL
IN
REMOTE 1
OUT
SC TRIGGER REMOTE 2
IN OUT
AC IN
RCA (female) to BNC (male) conversion adapter (not supplied)
Video cable (not supplied)
S-video cable (not supplied)
Audio equipment
Audio cable (not supplied)
NOTE: Refer to your VCR or laser disc player owner's manual for more information
about your equipment's video output requirements.
NOTE: An image may not be displayed correctly when a Video or S-Video source is
played back in fast-forward or fast-rewind via a scan converter.
2-16
2. Installation
AUDIO IN
L R