Seamless Switch (Gt6000 Only) - NEC GT6000 User Manual

Seamless Switch (GT6000 only)

1. What Does This Function Do?
This function provides a transition effect during source switch-
ing.
[Before switching]
[During switching]
* The drawings show an example of how "Effect-Wipe Right"
works.
2. Setting the Seamless Switch function.
2-1. Set effects and speed of the transition from source to source.
Select the Advanced Menu → [Projector Options] → [Seam-
less Switch].
• On/Off
Turns on or off the Seamless Switch function.
The default setting is "Off".
• Effect
Selects one of the six effects during source switching.
The default setting is "None".
None Displays a still image from the previously se-
lected source while switching to another source.
Wipe Down Displays a still image from the previously se-
Wipe Left lected source, then performs a wipe effect in a
Wipe Up desired direction while switching to another
Wipe Right source.
Box In Displays a still image from the previously se-
lected source, then performs a "box in" effect
while switching to another source.
Box Out Displays a still image from the previously se-
lected source, then performs a "box out" effect
while switching to another source.
• Speed
Select one of the three switching speeds: Fast, Medium and Slow.
The default setting is "Medium".
• Synchronize
[After switching]
The default setting is "Off".
Auto
Off
2-2. Set [Last Memory] or [Direct Key].
After turning on the Seamless Switch, be sure to do either
one of the following settings (1) or (2).
(1) Turn on "Last Memory" (Place a check mark in the "Last
Memory" check box.)
This setting enables the Seamless Switch function while
source is switching by using Source/Input (0-9) buttons on
the remote control.
(2) Register signals you want to use for the Seamless Switch
function in "Entry List". In doing so, do the "Direct Key"
setting.
This setting enables the Seamless Switch function while
source is switching by using the CTL button and Source/
Input (0-9) buttons on the remote control.
NOTE:
• With the Seamless Switch turned on, a signal with a higher resolution than
1024
ogy.
• When switching is performed using the Seamless Switch function between two
signals with different "Picture Management" settings, the hue of the image may
be changed immediately before source switching. This is because the Picture
Management settings will be changed along with source switching.
8-23
8. Using On-Screen Menu
Selecting "Off" can cause horizontal lines when a
moving image is displayed. If you want to delete
the lines, select "Auto". When "Auto" is selected,
the image can be distorted for a moment immedi-
ately after source switching.
Normally set to "Off".
768 (XGA) will be displayed using NEC's Advanced AccuBlend technol-