Troubleshooting - NEC GT6000 User Manual

x Troubleshooting
This section helps you resolve problems you may encounter while setting up or using the projector.
Power Indicator
Indicator Condition
Blinking light Green blinking
Orange blinking
Green
Steady light
Orange
Status Indicator
Indicator Condition
Blinking light Red blinking
Steady light Red (GT6000 only)
Orange
Green
Lamp 1/2 Indicator
Indicator Condition
Red blinking
Blinking light
Green blinking
Orange blinking
Steady light Red
Green
Orange
Off
0.5 sec ON,
0.5 sec OFF
2.5 sec ON,
0.5 sec OFF
0.5 sec ON,
0.5 sec OFF
2.5 sec ON,
0.5 sec OFF
Off
1 cycle (0.5 sec ON,
2.5 sec OFF)
2 cycle (0.5 sec ON,
0.5 sec OFF)
3 cycle (0.5 sec ON,
0.5 sec OFF)
4 cycle (0.5 sec ON,
0.5 sec OFF)
Off
2.5 sec ON,
0.5 sec OFF
1 cycle (0.5 sec ON,
2.5 sec OFF)
6 cycle (0.5 sec ON,
0.5 sec OFF)
7 cycle (0.5 sec ON,
0.5 sec OFF)
Projector Condition
The main power is off
The projector is getting ready to turn on.
Off Timer or Sleep Timer is active.
The projector is cooling down.
On Timer is active.
The projector is turned on.
The projector is in Standby or Idle.
Projector Condition
Normal
Lens hood or lamp cover error
Temperature error
Power error
Fan error
Circuit error
Control key locked
Idle condition
Projector Condition
Light off
Lamp has reached its end of life. Lamp
replacement message will be displayed.
No lamp
Lamp error
Lamp data error
Re-firing the lamp
Switching from Lamp 1 to 2
Lamp has been used beyond its limit. The
projector will not turn on until the lamp
is replaced.
Lamp mode is set to Normal mode
Lamp mode is set to Eco mode.
10-3
10. Appendix
Note
–
Wait for a moment.
–
Wait for a moment.
–
–
–
Note
–
Replace the lens hood or the lamp cover
correctly.
The projector is overheated. Move the
projector to a cooler location.
Power unit will not work correctly.
Cooling fan has stopped. Contact your
dealer.
An error occurs in the circuit. Consult
your dealer.
You have pressed control panel key when
Control Key Lock is enabled.
–
Note
–
Replace the lamp.
Lamp is not installed. Turn off the power
and install lamp.
Lamp fails to light. Wait a full minute and
turn on the power again. If this will not
solve the problem, consult your dealer.
Fails to read lamp data.
Consult your dealer.
Wait for a moment.
Wait for a moment.
Replace the lamp.
–
–