To Connect Scart Output; Connecting An External Monitor - NEC GT6000 User Manual

To connect SCART output (RGB)
Before connections: An exclusive SCART adapter (ADP-SC1) and a
commercially available SCART cable are required for this connection.
NOTE:
• Audio signal is not available for this connection.
• The RGB 1 IN connector does not support Plug & Play.
Video equipment
such as DVD player
Commercially available
SCART cable

Connecting an External Monitor

RGB signal cable
(not supplied)
To mini D-Sub 15-pin connec-
tor on the projector.
You can connect a separate, external monitor to your projector to simulta-
neously view on a monitor the RGB analog image you're projecting. To do
so:
1. Turn off the power to your projector, monitor and computer.
2. Use a 15-pin cable to connect your monitor to the RGB OUT
(Mini D-Sub 15 pin) connector on your projector.
3. Turn on the projector, monitor and the computer.
Projector
DVI
AUDIO
AUDIO OUT RGB 1
SLOT 1 SLOT 2
L/MONO L/MONO
R R
AUDIO
RGB 2
R/Cr
RGB OUT G/Y
RGB 2
B/Cb
VIDEO S-VIDEO
H/
HV
V
L/MONO L/MONO
R R
To RGB 2 IN
Female ADP-SC1
AUDIO OUT RGB 1
L/MONO L/MONO
R R
AUDIO
RGB 2
R/Cr
G/Y
RGB OUT
B/Cb
VIDEO S-VIDEO
RGB OUT
H/
HV
V
L/MONO L/MONO
R R
Audio cable
(not supplied)
PHONE
1. Turn off the power to the projector and your video equipment.
2. Use the NEC ADP-SC1 SCART adapter and a commercially
available SCART cable to connect the RGB 2 input of your
projector and a SCART output (RGB) of your video equipment.
3. Turn on the power to the projector and your video equipment.
4. Use the RGB 2 button on the remote control to select the RGB
2 input.
5. Press the MENU button on the remote control to display the
2
USB A USB B PC CARD 1
menu.
LAN
PC CONTROL
IN
REMOTE 1
OUT
SC TRIGGER REMOTE 2
IN OUT
6. From the Advanced menu, select [Projector Options] → [Setup]
AC IN
→ [Page 3] → [Signal Select RGB2] → [Scart].
SCART is a standard European audio-visual connector for TVs,
VCRs and DVD players. It is also referred to as Euro-connec-
tor.
NOTE: The ADP-SC1 SCART adapter is obtainable from your NEC dealer in Europe.
Contact your NEC dealer in Europe for more information.
DVI
AUDIO
SLOT 1 SLOT 2
NOTE:
• The RGB OUT connector outputs an RGB signal during idle mode (See page 8-
15). When the projector goes into idle mode, the image on an external monitor
disappears for a moment. Note that the RGB OUT connector will not output an
RGB signal during Standby mode.
• When the projector is in the Idle mode, the image may not be correctly dis-
played while the cooling fans are running immediately after turning on or off the
power. Note that the RGB OUT connector will not output an RGB signal during
Standby mode.
• Daisy chain connection is not possible.
2-14
USB A USB B PC CARD
LAN
PC CONTROL
IN
REMOTE 1
OUT
SC TRIGGER REMOTE 2
IN OUT
AC IN
Audio cable
(not supplied)
LINE IN
RGB signal cable
(not supplied)
To mini D-Sub 15-pin connec-
tor on the projector.
2. Installation