Maintenance; Service Schedule - Windsor CLP12 Operating Instructions Manual

Service Schedule

Check machine for cord damage.
Check recovery dome and gasket for damage and cleanliness.
Check brush - should be clean with no lint or strings attached.
Inspect vacuum shoe for blockage; remove fibers with coat hanger, etc.
Check hoses for wear, blockages, or damage.
Check handles, switches, and knobs for damage.
Check vacuum motor intake filter and clean.
Run one gallon of water through system.
Clean out recovery tank and check float valve to make sure it moves freely.
Clean out solution tank and remove and clean vacuum intake screen.
Clean outside of all tanks and check for damage.
Run vacuum motor for at least one minute to allow motor to dry.
Store with dome off tank to allow the tank to dry.
Check all bearings for noise
Check all gaskets for wear and leakage
Check vacuum intake screen for damage; replace if necessary.
Check pump pressure; observe spray pattern and check with gauge if
necessary
Check and clean solution screen.
Check belts for wear and replace as necessary.
Check brush for wear; ensure bristles are not damaged.
Check cables for fraying.
Check the spray bar (manifold) for damage; replace if broken or bent.
Check condition of vacuum shoe and frame for damage.
Check overall performance of machine.
Check vacuum motor carbon brushes.

Maintenance

86403890 Manual Operators - Clipper 12 - 230V
Maintenance
Daily Weekly Quarterly
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
25