Troubleshooting Service Conditions - C&K systems Sierra User Manual

Troubleshooting Service Conditions

Your system notifies you if a keypad, sensor, or other system com-
ponent, needs service by lighting the Service LED and by beep-
ing twice every 30 seconds for one minute.
To get more information about the service message, press and
hold the
beeps. One or more of the LEDs of Zones 5, 6, 7, and 8 light. As
the table below shows, different messages are conveyed depend-
ing on which LEDs are lit. (In the table, lit LEDs are shown in
black.) Follow the recommended course of action listed in the
table.
To stop the service message warning tone, enter your user code
6
between the two beeps.
You may have more than one service message. To view the next
message, press the
sages, your keypad exits the Service Message display.
LEDs
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
48
[service] key for two seconds until you hear two
key again. If there are no new mes-
Message
A system component
has been vandalized.
A system component is
not communicating with
the control panel.
A keypad has been
vandalized.
(Table continued on next page)
What to do
Call for service.
Call for service.
Call for service.