TYAN S1830 User Manual page 22

Chapter 2
Board Installation
right next to the Pentium II CPU slot.
Insert the heat sink mount into the holes on the motherboard. When the
bracket is properly inserted into the holes on the motherboard, you will hear a
clicking noise.
Align the CPU with the CPU retention module. Make sure the heat sink is lined
up with the heat sink mount bracket. If you put the CPU in the wrong way, you
may damage the CPU, the motherboard, and/or the CPU socket. Slowly press
down on the CPU module until the CPU locks into place. You will hear a
clicking noise when the CPU is locked securely into the module.
The heat sink lock (Figure 19)
has four notches which will
correspond to the four pins on
the heat sink mounting bracket.
Gently slide the lock between
the heat sink and the heat sink
mounting bracket until both
sides of the lock are firmly secured. A clicking sound will be heard when the
lock is securely fastened to the heat sink mounting bracket. To remove the lock
from the heat sink mounting bracket, gently press the ends of the locks inward
and pull.
Lock the heat sink mount to the board by
inserting the two mounting locks (Figure 20) into
the pins of the heat sink mounting bracket which
are now below the mainboard. There will be a
click when the locks are securely fastened.
Figure 18
Figure 19
22
Figure 20
http://www.tyan.com