Peripheral Setup - TYAN THUNDER 2 ATX Manual

Peripheral Setup

Peripheral Setup options are displayed by choosing Peripheral Setup
from the AMIBIOS Setup main menu. All Peripheral Setup options are
described here.
Onboard FDC
Set this option to Enabled to enable the floppy drive controller on the
motherboard. The settings are Auto (AMIBIOS automatically deter-
mines if the floppy controller should be enabled), Enabled, or Dis-
abled. The Optimal and Fail-Safe default settings are Enabled.
Onboard Serial Port1
This option specifies the base I/O port address of serial port 1. The
settings are Auto (AMIBIOS automatically determines the correct base
I/O port address), Disabled, 3F8h, 2F8h, 2E8h, or 3E8h. The Optimal
and Fail-Safe default settings are Auto.
Onboard Serial Port2
This option specifies the base I/O port address of serial port 2. The
settings are Auto (AMIBIOS automatically determines the correct base
I/O port address), Disabled, 3F8h, 2F8h, 2E8h, or 3E8h. The Optimal
and Fail-Safe default settings are Auto.
Serial Port2 Mode
This option specifies the operating mode for serial port 2.This option
only appears if the Onboard Serial Port2 option is not set to Auto or
Disabled. The settings are IrDA, ASK IR, or Normal. The Optimal and
Fail-Safe default settings are Normal.
IR Transmission Mode
This option specifies the infrared transmission method. This option
only appears if the Onboard Serial Port2 option is not set to Auto or
Disabled. The settings are Full Duplex or Half Duplex. There are no
default settings.
55