Anti-Virus Security - TYAN S1830 User Manual

When you select the Supervisor Security option, a dialog box (shown below)
will appear, allowing you to enter a password. You may either type the pass-
word in, or click on the onscreen buttons. Your password must be between
one and six characters long.
Once you have entered your new password, you will be asked to confirm it. If
the two passwords do not match, you will be prompted to enter a new pass-
word, and then to confirm it. This will continue until you enter the same series
of characters both times. Once this is accomplished, a dialog box will appear
and notify you that the Supervisor Password has been installed. You may then
select the User Security option and enter a password for the user.
You can enter a new User password at any time simply by selecting the User
Security option, and typing in a new password. To enter a new Supervisor
password, select the Supervisor Security option. You will be asked to enter the
current password. After you do so, you will be prompted to enter the new
password.
In either the Supervisor or User Security options, pressing <Enter> once when
asked for a new password, and a second time when asked to confirm the new
password, will uninstall the existing password. Note that uninstalling the
Supervisor password uninstalls the User password as well. (If you forget your
password, see page 28.)

Anti-Virus Security

If Enabled, the virus protection program helps you monitor your system for
viruses. During and after the system boot up, any attempt to write to the boot
S1830 Tsunami AT
59