Table of Contents
Advertisement
English
Installation
To fix the cooker hood please choose one of
the following options:
a) Fix it to the upper part of the furniture
Figure 3 must be used where the position
of the holes is indicated.
b) Fix it to the internal laterals of the
furniture:
1.- Screw two screws to each side of the
furniture interior
following figure 5
instructions. Leave them 3 mm loose for
adjustment.
2.- Screw the provided brackets to the top
part of the hood, keeping the internal
furniture width.
3.- Hold and rise the hood until the slots of
their brackets fit in the screws (step 1)
of the furniture.
4.- Keeping the appliance hold, push it
towards furniture's bottom until screws
fits into a stable position inside the slots.
5.- Rise the hood a little until a definitive
position is obtained and tight the loosen
four screws to the brackets.
The lower part of the extractor must be
installed a minimum height of 50 cm
above the hob for electric cookers and 65
cm for gas cookers. (If the installation
instructions of a gas cooker indicate a
greater distance this must be observed).
The KSET910X cooker hood only can be
installed in furniture of 90 cm.
When the extractor is working at the same
time
as
other
non-electrical
cooking
equipment, the outlet air pressure must not
-5
exceed 4 Pa (4 x 10
bar).
To achieve optimum performance the length
of the outlet hose should not exceed 4
meters, or include more than two 90º angles
(elbows)
CAUTION: Accessible parts may become hot
when it is used with cooking appliances.
Although
venting
to
the
outside
recommended, active carbon filters may be
used, which allow the purified air to be
returned to the kitchen through the outlet
pipe.
If you wish to substitute the front panel and
replace it with one matching the kitchen
units, follow the following instructions (Fig.2):
* Withdraw the movable group.
* Remove the screws (T) that support the
front.
* Install the new front fixing it with the same
screws that held the old one.
If something does not work
Before seeking technical assistance carry
out the following checks first:
Om någonting inte fungerar
Innan du kontaktar verkstad gå efter följande
instruktioner:
FEL
Kontakten är inte isatt
Fläkten fungerar inte
Det kommer inte ström i
kontakten
Filtret är fullt med fett
Fläkten suger inte
Tilltäppning i utgångsröret
upp tillräckligt eller
Fel utgångsrör
vibrerar
Lamporna är utbrända
Lamporna tänds inte
is
Lösa lampor
SMEG. förbehåller sig rätten att göra ändringar för att förbättra sina produkter om de anser det
nödvändigt utan att detta försämrar produkten.
MÖJLIG ORSAK
Sätta i kontakten
Försäkra dig om att det finns el
Rengör filtret eller byt ut det
Ta bort tilltäppningen
Kontakta installatören och följ
instruktionerna i denna
bruksanvisning
Byt ut lamporna
Skruva åt lamporna
LÖSNING
Advertisement
Table of Contents
