Smeg KSET610X Instruction Manual page 5

1.-
A
Velocità Snelheid Absaugleistung Скорость Velocidade Hastighet
Speed Vitesse Velocidad
I
Low Moyenne Baja Bassa
II High Maximum Alta Alta
+ Intensive Intensive Intensiva Intensa
Light Lumière Luz Luce
On Allumé Encendido Accesa
Off Eteint Apagado Spenta
2.-
T
C
Низкая
Laag Leistungsstufe Baixa
Высокая
Hoog Intensivstufe Alta
Интенсивная
Intensief Intensiv Intensiva
Освещение
Licht Beleuchtung Luz
Включено
Aan Ein Acesa
Отключено
Uit Aus Desligada
Instructions for use
By pushing buttons shown in the figure 1,
you will be able to control the functions of the
extractor
Two achieve better
recommend switching on the extractor a few
minutes before starting to cook (3 - 5
minutes) so that the air flow is continuous
and stable when extracting the fumes.
Likewise, keep the extractor switched on for
E
a few minutes when cooking is complete to
allow all fumes and odours to be expelled.
D
Cleaning and maintenance
Before carrying
maintenance activities, ensure that the
A
extractor is disconnected from the mains.
To carry out cleaning and maintenance,
B follow the Safety Instructions.
There is a fire risk if cleaning is not carried
out in accordance with the instructions.
Filter cleaning
To remove the filters from their locations
Låg
release the anchoring points. Clean the filter,
Hög either by putting it in the dishwasher (see
notes) or leaving it standing in hot water to
Intensiv
simplify the removal of grease or, if wished,
Lampa
by means of special sprays (protecting the
På
non metallic parts). Once clean, leave it to
Av
dry.
Notes: cleaning in the dishwasher with
aggressive detergents may
surface of metallic
affecting its gas retaining properties.
N.B. The filter must be cleaned at least once
a month depending on how often the
extractor is used. It must be remembered
that grease accumulates in the extractor
when cooking, whether it is switched on or
not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor,
paying special attention
Afterwards, dry it using a lint-free cloth.
Note:
* Never use metallic scouring pads or
abrasive products that could damage the
surface.
* Do not use scrapers with metallic surfaces
such as knives, scissors etc.
extraction, we
Active charcoal filter
* To install
necessary to firstly remove the metallic
grease filters.
* In order to fix them it is necessary to
introduce the rear lips of each filter in the
holes provided for it in the security grid,
turning them upwards until its fixation by
clipping in the front part (Fig.6).
* The carbon filters last from three to six
months
out any cleaning or
conditions of use.
* The active carbon filters can neither be
washed nor regenerated. Once they are
exhausted, they must be changed.
* To replace worn out filters with new ones,
remove the old ones in the reverse order
to that of installation
Changing Bulbs
* It is
disconnected, and ensure the bulbs that
are to be replaced are not hot.
* Remove the light lens to expose the
extractable lamps.
* The maximum bulbs power is 20W.
Technical Information
Dimensions
darken the
parts, without this
Electrical characteristics:
REFER TO RATING PLATE
to the grids.
the charcoal filters it is
depending on the particular
.
important that the mains are
(Fig.3)
Width = 600//900 mm
Depth = 300 mm
Height = 353 mm