Quick Start - NEC MultiSync E750 User Manual

Quick Start

To attach the MultiSync
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1 for MultiSync E
and Figure A.2 for MultiSync E
For the Mac: Connect the MultiSync E
adapter (not included) to the monitor connector on the Macintosh (Figure B.1).
Attach the 15-pin mini D-SUB end of the captive signal cable to the Macintosh
cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync E
adapter, call NEC Technologies at (800) 820-1230.
4. For download information
on the Windows
INF file for your MultiSync
monitor, refer to the
References section of this
User's Manual.
5. Connect one end of the
power cord to the
MultiSync E Series monitor
and the other end to the
power outlet (Figure C.1 for
MultiSync E
750
C.2 for MultiSync E
6. Turn on the monitor (Figure
D.1) and the computer.
NOTE: If you have any
problems, please refer
to the Troubleshooting
section of this User's
Manual.
78134381.wpc
E Series monitor to your system, follow
®
™
950
or MultiSync E
750
95/98
®
and Figure
).
950
5
). Tighten all screws.
or MultiSync E
750 950
Macintosh cable
950
Captive Signal Cable
MultiSync E
750
Figure A.1
Captive Signal Cable
15-pin mini D-SUB
MultiSync E
950
Figure A.2
3
11/25/98, 2:39 PM
™
750
Macintosh cable
15-pin mini D-SUB