Advertisement
W
iring diagram
(1) Wiring in Housing (R)
Fig. D-2
[Routing Lead wires (black, red) of Endbell complete]
Black wire: Route beside the right side of the LED cover
portion of Controller, then connect to No. M2
terminal of Switch section.
Red wire: Route beside the left side of the LED cover
portion of Controller, connect to No. M1
terminal of Switch section.
Place the following parts outside of Housing (R):
• Connectors and Lead wires (purple, yellow)
that connect Controller with Switch unit
• Connectors and Lead wires (gray, blue)
that connect Controller with LED circuit
LED circuit
Route the following four
Lead wires between the rib
and the inside wall of
Housing:
Lead wires (black, red)
of Terminal
Lead wires (white, red)
of Buzzer circuit
Put the Connectors
in the space between
this line and Terminal.
Locate Line filter
in this position
in case it is used.
Be sure to place Sponge
of Buzzer circuit on
Housing (L) side.
Note: See next page for wiring of Switch unit and Switch section.
Switch unit
Controller
Switch
rib
Connector
Buzzer
circuit
Endbell complete
Controller
Route the following seven Lead wires
of Controller between the ribs of
Switch section:
• two wires (white, orange)
to Micro switch of Switch section
• three wires (blue, purple, white)
to Reverse switch of Switch section
• two wires (red, white)
to Buzzer circuit
Note:
Be careful not to pinch these
Lead wires between Switch section
and the inside wall of Housing.
P 13/ 14
Lead wire (black)
LED cover portion
Lead wire (red)
rib
Advertisement
