Korg SP-280 Owner's Manual page 8

Adjust the volume
Rotate the VOLUME knob that's located next to the power switch toward "MAX"
to raise the volume level.
Rotate it left toward "MIN" to lower the level. (Fig. 3)
The VOLUME knob controls the output level of the built-in speakers, the head-
phones jacks and the LINE OUT jacks.
It is always better to start with a low volume and then increase gradually.
Using the LINE IN/LINE OUT jacks
Use the LINE IN jack to listen to the sound from another musical instrument or
sound system through the speakers of the SP-280.
Connect this jack to the output jack of the other musical instrument or sound
system.
Use an audio cable with a stereo mini plug inserted into the SP-280 and a plug
on the other end appropriate for the connected device.
Use the LINE OUT jacks, if you want to connect your SP-280 to a mixer, stereo
hi-fi, or a couple of active monitors. When using a stereo hi-fi, connect the LINE
OUTs to the AUX or LINE inputs. For mono amplification, connect only the L/
MONO jack.
You must only connect devices with the power turned off. Careless opera-
tion may damage the SP-280 or the device where it's connected, or malfunc-
tions may be caused .
Connection cables are sold separately. You will need to obtain the appropri-
ate commercially-available cables for your equipment.
8