Mode 2 - Real Time - NCR 7870 User Manual

7-60 Chapter 7: Programming
Scanning the Mode 1 tag again changes the display sequence to the
next tally count. Continue to scan the Mode 1 tag to view all tally
counts. The tally count information is displayed in order according to
the tally count number (C1 – C5).
Exit Mode 1 by pressing the Scale Zero Button on the Operator Display
Panel or by scanning the Mode 2 tag.

Mode 2 - Real Time

Enter Mode 2 by scanning the Mode 2 tag.
The scanner goes off-line and disables the scale so that the integrated
display or the NCR 7825 Remote Display can show Ready 4 label.
Every subsequent scan until the scanner is powered off (or the Scale
Zero Button is pressed) causes the scanner to indicate the status of label
readability. The scanner can recognize missing bars in labels, highly
over/under printed labels, missing margins, or a no-read condition.
If you scan a UPC/EAN label for analysis, the display shows label
followed in one second by the display of the first half of the UPC/EAN
label. If the label is a version E, no second half is displayed, since the E
label is only six digits in length. After another two-second pause, the
display shows CODE xx where "xx" is a code number to indicate one of
the following.
C3 03.4
1136
Note: These displays alternate every three seconds.
Tally Count 3
3.4% of Good Reads
Tally Count = 1136
16566