Information; In Case Of Difficulty - Alpine cda-9886 Quick Reference Manual

Information
In Case of Difficulty
If you encounter a problem, please tum the power off, then on again. If
the unit is still not functioning normally, please review the items in the
following checklist. This guide will help you isolate the problem if the
unit is at fault. Otherwise, make sure the rest of your system is properly
connected or consult your authorized Alpine dealer.
No function or display.
• Vehicle's ignition is off.
· If connected following instructions, the unit will not operate
with the vehicle's ignition off.
• Improper power lead (Red) and battery lead (Yellow)
connections.
· Check power lead and battery lead connections.
• Blown fuse.
• Check the fuse of the unit; replace with the proper value if
necessary.
• Internal micro-computer malfunctioned due to interference noise
etc.
• Press the RESET switch with a ballpoint pen or other pointed
article.
Unable to receive stations.
• No antenna or open connection in cable.
· Make sure the antenna is properly connected; replace the
antenna or cable if necessary.
Unable to tune stations In the seek mode.
You are in a weak signal area.
· Make sure the tuner is in the OX mode.
If the area you are in is a primary signal area, the antenna may
not be grounded and connected properly.
· Check your antenna connections; make sure the antenna is
properly grounded at its mounting location.
The antenna may not be the proper length.
· Make sure the antenna is fully extended; if broken, replace the
antenna with a new one.
Broadcast Is noisy.
• The antenna is not the proper length.
· Extend the antenna fully; replace it if it is broken.
• The antenna is poorly grounded.
- Make sure the antenna is grounded properly at its mounting
location.
CD Player/Changer not functioning.
• Out of operating temperature range +50°C (+ 120°F) for CD.
- Allow the vehicle's interior (or trunk) temperature to cool.
CD playback sound is wavering.
• Moisture condensation in the CD Module.
- Allow enough time for the condensation to evaporate (about I
hour).
40-EN
MP3, WMA or AAC Is not played back.
• Writing error occurred. The MP3IWMNAAC format is not
compatible.
- Make sure the MP3IWMNAAC has been written in a
supported format. Refer to "About MP3IWMNAAC"
(pages 12-13). then rewrite in the format supported by this
device.
The sound Is not output from the speakers.
• Unit has no output signal of the internal amplifier.
- Power IC is switched to "ON" (page 20).
iPod does not play and no sound Is output.
• The iPod has not been recognized.
- Reset this unit and the iPod. Refer to "Initial System Start-Up"
(page 7). To reset the iPod, refer to the Owner's Manual of the
iPod.
Information
In Case of Difficulty
If you encounter a problem, please tum the power off, then on again. If
the unit is still not functioning normally, please review the items in the
following checklist. This guide will help you isolate the problem if the
unit is at fault. Otherwise, make sure the rest of your system is properly
connected or consult your authorized Alpine dealer.
No function or display.
• Vehicle's ignition is off.
· If connected following instructions, the unit will not operate
with the vehicle's ignition off.
• Improper power lead (Red) and battery lead (Yellow)
connections.
· Check power lead and battery lead connections.
• Blown fuse.
• Check the fuse of the unit; replace with the proper value if
necessary.
• Internal micro-computer malfunctioned due to interference noise
etc.
• Press the RESET switch with a ballpoint pen or other pointed
article.
Unable to receive stations.
• No antenna or open connection in cable.
· Make sure the antenna is properly connected; replace the
antenna or cable if necessary.
Unable to tune stations In the seek mode.
You are in a weak signal area.
· Make sure the tuner is in the OX mode.
If the area you are in is a primary signal area, the antenna may
not be grounded and connected properly.
· Check your antenna connections; make sure the antenna is
properly grounded at its mounting location.
The antenna may not be the proper length.
· Make sure the antenna is fully extended; if broken, replace the
antenna with a new one.
Broadcast Is noisy.
• The antenna is not the proper length.
· Extend the antenna fully; replace it if it is broken.
• The antenna is poorly grounded.
- Make sure the antenna is grounded properly at its mounting
location.
CD Player/Changer not functioning.
• Out of operating temperature range +50°C (+ 120°F) for CD.
- Allow the vehicle's interior (or trunk) temperature to cool.
CD playback sound is wavering.
• Moisture condensation in the CD Module.
- Allow enough time for the condensation to evaporate (about I
hour).
40-EN
MP3, WMA or AAC Is not played back.
• Writing error occurred. The MP3IWMNAAC format is not
compatible.
- Make sure the MP3IWMNAAC has been written in a
supported format. Refer to "About MP3IWMNAAC"
(pages 12-13). then rewrite in the format supported by this
device.
The sound Is not output from the speakers.
• Unit has no output signal of the internal amplifier.
- Power IC is switched to "ON" (page 20).
iPod does not play and no sound Is output.
• The iPod has not been recognized.
- Reset this unit and the iPod. Refer to "Initial System Start-Up"
(page 7). To reset the iPod, refer to the Owner's Manual of the
iPod.