Norcool G3 Operating & Installation Instructions Manual page 69

8. Installation
4. The magnetic seal can be compressed after being packed and transported. It will return to its original shape a while
after being unpacked. Door can be adjusted using adjustment plate supplied if the seal is compressed - see fig. 6B. If the
magnetic seal is pressed too hard on door seal or is twisted; open door 90° and loosen hinge screws to floor/ceiling, move
adjustment plate inwards between hinge and ceiling/floor and screw securely. See fig. 6A.
5. Handle: The desired handle must be fastened vertically 25 mm from the outer edge of the fridge door to the centre hole.
The screw length depends on the handle and thickness of the furniture panel (thickness of fridge door is 35 mm). Drill the proper
number of holes. Washers should be used for better fastening. Thread washer on screw and fasten with handtool.
6. Air grilles. Cut an opening in plinth for air grille. The opening must be 448mm x 56mm.
8.5. Fitting furniture sides (see figure 9)
1. Preparation: Corner fridge must be in place without shelves and other internal fixtures in kitchen with door and front fitted.
2. Fasten furniture sides. Drill hole in external steel plate through bushings using Ø4 mm drill. NOTE! Drilling and
screwing must not be done at places in the wall other than in through bushings since such may
ruin the design and insulating capability. Position cover sides level with upper edge of corner fridge and pull as far
forwards towards furniture front as possible to minimise gap between front and cover side. Mark hole position on furniture front
using a long awl through drilled holes on cover sides. For min. 16mm kitchen front thickness, pre-drill min. 10mm in marked hole
in cover side using a Ø2.5 mm drill. The screws supplied (4.0 x 30 mm) will extend 9mm into the cover side.
NOTE: Take into account the kitchen front thickness to avoid drilling through.
Replace the cover side and screw into place. Seal holes with plastic plugs. Any gaps left between the cover side and kitchen
wall can be sealed with sealant or a moulding strip. The rest of the kitchen can now be fitted.
102,5 cm
60 cm
Fig 9
Integration - distances
69