Troubleshooting - Worx WX314 Original Instructions Manual

3. Pilot holes
When drilling a large hole in tough material
(i.e. steel) , we recommend drilling a small
pilot hole first before using a large drill bit.
4. Drilling tiles
Select the drill/impact action selector switch
to the "drill symbol" position to drill the tile.
When tile has been penetrated, switch over to
"hammer symbol" position.
5. Cool the motor
If your power tool becomes too hot, set the
speed to maximum and run no load for 2-3
minutes to cool the motor.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
10
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.

TROuBLESHOOTING

1. If your drill will not operate, check the power
at the mains plug.
2. If the drill is not drilling properly, check the
drill bit for sharpness, replace drill bit if worn.
Check that the drill is set to forward rotation for
normal use.
3. If a fault can not be rectified return the drill
to an authorized dealer for repair.
Impact Drill
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
EN